Creek-audio Destiny Integrated User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Destiny Integrated Amplifier
SPECIFICATION
Measured at 230V or 115V
Not recommended for use into more than 2 pairs of 8 Ohm speakers
Power Output into 8W (both channels driven) at rated mains voltage > 100 Watts
Dynamic Power Output into 8W > 150 Watts
Power Output into 4W (both channels driven) > 160 Watts
Dynamic Power Output into 4W > 250 Watts
Dynamic Power Output into 2W > 380 Watts
Dynamic Power Output into 1W (Limited by protection) > 250 Watts
Total Harmonic distortion (20 Hz to 20 kHz) < 0.02%
Frequency Response -1dB 1 Hz to 30 kHz
-3dB 0.1 Hz to 65 kHz
Slew Rate > 50 V per µS
Gain in passive pre-amp mode x48 or 33.6dB
Gain increase with active built in pre-amp 0dB +3dB +6dB +9dB
(Switchable voltage gain with slider switch under pre-amp section)
Input Sensitivity for 100W into 8W 589mV 392mV 294mV 210mV
Input Impedance of power amp section 11 k W
Power Amp Output Impedance 100 Hz @1kHz) > 0.034
Damping Factor > 235
Pre-amp output level Follows input level via volume control
Signal to Noise Ratio ('A' weighted re 0 dB) > 78 dB
Separation (Crosstalk @ 1 kHz) > 60 dB
Maximum mains power consumption 400 Watts
Standby Power Consumption > 1 Watt
Input socket type 3 pin IEC, grounded
Loudspeaker outputs 2 x Switchable A+B
(8 x screw terminals)
Switchable mains voltage selector 115/230 V AC external
Inputs (Input 1 can be configured for a phono plug in) 5 x line level plus tape
Input socket type (unbalanced) Gold plated RCA (Phono or cinch)
Headphone output 6.4mm (1/4”) Jack on front panel
Pre-amp putput and power amp input connection Switchable on rear panel
Weight (net) 10 kgs 22 lbs
Size (W x H x D) mm 430 x 70 x 310
inches 16.9 x 2.7 x 12.2
Remote control Fully remote from Creek SRC2 handset
Serial Bus (Required Creek serial interface) CAN Bus serial link via 2 RJ45 sockets
MAINS VOLTAGE AND FREQUENCY IS INTERNALLY SET FOR THE COUNTRY OF USE
Creek Audio Ltd reserves the right to change or modify the specification of its products without prior warning
WARRANTY
If within two years of purchase date your Destiny product proves to be defective for any reason other than accident, misuse,
neglect, unauthorized modification, or fair wear and tear, Creek Audio Ltd. will, at its discretion, replace the faulty parts
without charge for labour or return carriage within the U.K.
This warranty is valid only in the U.K. and given in addition to statutory rights.
Service enquiries outside the U.K. should be addressed first to the supplying dealer and/or the Creek
distributor/importer. Warranties granted in these countries are entirely at the discretion of the distributor.
Creek Audio Limited
12 Avebury Court, Mark Road, Hemel Hempstead HP2 7TA England
Telephone: +44 (0) 1442 260146 Fax: +44 (0) 1442 243766
Internet: www.creekaudio.com
Page view 3
1 2 3 4

Comments to this Manuals

No comments